Simplified Chinese Japanese EnglishTraditional Chinese
HOME About YS Product Achievement FAQ Technic Area Content US
Add Bookmark    
My Favorite    

Back Online Catalogue
> Back Specification Downloads > YS-EA Seismic Snubbers for pump

Air Mounts
Air Spring Mounts
Floor Springs Mounted
Spring Mounts
Suspended-Spring Isolators
Spring &Rubber Hangers Overview
Suspended-Neoprene Isolators
Spring & Rubber Mounts Overview
Neoprene Mounts
Seismic Snubber
Seismic Snubbers for Pumps
Piping Specialties
Isolation Bases
Flexible Connectors
GMT Pads
Others Isolators Overview
Seismic Mounts
Cabin air springs and Rubber sleeves
Portable Air Jacks
Refurbished Shock-Mercedes-BENZ Air Suspension
Rolling Lobe
Modiefied Car for Air springs

Easy installation

A neoprene pad,approx 9~13mm thickness, is affixed at the point of contact.

Rubber is made bu Butyl rubber,its hardness is 70.

Minimum of one snubber per side, four total, is required o neach base.

Test report for YS-EA MODEL is available.
Download Catalogue

H(mm) Spring rate
YS-89EA 160 89 60 60 525
YS-135EA 160 135 60 60 1050
YS-180EA 160 135 60 60 1050
¤U¹Ï¤À§O¬°YS-180EA ¥H¤ÎYS-270EA¹ê«~¹Ï¡C


Prior to grouting, please place wooden planks or PE bags under the base to prevent contact and adhesion to the floor.

Remove the wooden planks or PE bags after cement is dry. Before installing the pump and piping, place wood or iron blocks (approx. 25mm thick) below the base as support to suspend the base.

After piping has been completed, install the spring snubber (YS-C). Rotate with 7/8¡¨ bolt in anti-clockwise direction and the snubber base will rise. Adjust until the snubber supports the base completely.

Remove the wood or iron blocks to complete the installation

Snubbers is suggested to fully installed until vibration isolators are in place and adjusted with actial operating loads.







Best viewed with IE 5.0 or above; 1024x768(High color)
Copyright c 2006 HARMONY RUBBER INDUSTRY CO., LTD. All Rights Reserved.